UART UAVCAN cable set for EPM V3 R5C.
$7.50
Standard UAVCAN cable, also compatible with Pixracer
1x CAN bus termination plug - JST-GH plug with a 120 Ω resistor between the pins CAN H and CAN L.
1x CAN bus termination plug - JST-GH plug with a 120 Ω resistor between the pins CAN H and CAN L.
1x 20 cm twisted pair cable with a standard JST GH 1mm Micro plug on one end and a DF 13 4-circuit plug (3D Robotics Pixhawk compatible) on the other end.
External Button
1x JST-GH plug -> Push Button SPST
Documentation: docs.zubax.com
Programming JST-GH plug pigtail for firmware flashing and UART access
1x JST-GH plug pigtail
Requires FTDI cable, 3.3[V] preferred, 5[V] acceptable
Firmware Flashing / Debug Documentation: Github OpenGrabe EPM V3
1x CAN bus termination plug - JST-GH plug with a 120 Ω resistor between the pins CAN H and CAN L.
1x 20 cm twisted pair cable with a JST GH connector (4 circuits 1mm) on both ends. (Pixracer compatible)
3D Robotics Pixhawk compatible1x CAN bus termination plug - JST-GH plug with a 120 Ω resistor between the pins CAN H and CAN L.
1x 20 cm twisted pair cable with a standard JST GH 1mm Micro plug on one end and a DF 13 4-circuit plug (3D Robotics Pixhawk compatible) on the other end.
External Button
1x JST-GH plug -> Push Button SPST
Documentation: docs.zubax.com
Programming JST-GH plug pigtail for firmware flashing and UART access
1x JST-GH plug pigtail
Requires FTDI cable, 3.3[V] preferred, 5[V] acceptable
Firmware Flashing / Debug Documentation: Github OpenGrabe EPM V3